Setting Up - Minelab SDC 2300 Instruction Manual

1. Release armrest strap
Loosen the armrest strap and slide off of the
coil pivot to release the shaft assembly.
2. Fold out coil/shafts
Fold the coil/shaft assembly out until it clicks
into place.
3. Slide up handle assembly
Slide the handle assembly forwards and
upwards until it clicks into position. This will
also lock the shafts.

Setting Up

4. Extend and open armrest
Slide the armrest backwards until it stops.
Open the armrest wings outwards.
5. Rotate coil into position
Rotate the coil forwards 180° in line with the
shafts. Turn the coil 90° so that it is horizontal.
6. Extend shafts
Unlock the upper and lower camlocks and
extend the middle and lower shafts to a
comfortable detecting length. Lock the upper
and lower camlocks.
3