Maytag MSB2154DRA User Manual page 5

Interior Features ....................................................
Shelves
Tempered Glass Cantilever Shelves Elevator
TM
Shelf (select models)
These shelves are adjustable so the refiigerator interior The Elevator
TM
shelf is equipped with a spill-retaining
can be customized for varying food storage needs, edge and the Easy Glide slide-out feature. It can be
adjusted up or down without unloading. To slide out,
grasp the front of the shelf and pull forward. Push the
shelf in to return to original position.
To adjust the ElevatoF" shelf: Unfold the recessed
crank handle so it is at a right angle to the shelf front.
Crank to the right (clockwise) to raise the shelf, or to the
left (counterclockwise) to lower the shelf.
To remove: Unload the shelf. Grasp the shelf front and
pull completely forward. Press up on the stops (both
To remove a shelf: Unload. Lift up the rear of the shelf sides) and continue pulling the shelf forward, clear of
the frame.
slightly, pull the shelf straight out.
To move a shelf to a different position: After To replace: Align the shelf to the frame and push it all
removing, tilt up the front edge of the shelf. Insert the the way back. It is not necessary to depress the stops for
reinstallation.
hooks into the desired openings and let the shelf settle
into place. Be sure the shelf is securely locked at the rear. In ordinary use, the Elevator'" shelf frame assembly does
NOT require removal. Though unlikely, and not recom-
mended, the correct removal procedure is as follows:
Spill-Catcher
TM
Shelves (select models)
• Unload the shelf completely.
Spill-Catcher '_' s helves have a spill retainer edge to con- • Slide the shelf forward about two inches and manu-
tain spills and make clean-up easier, ally move the two rear latches toward the shelf center.
Some Spill-Catcher '_'shelves, feature the Easy Glide • While supporting the entire shelf and frame from
slide-out feature. To slide out, grasp the front of the underneath, lift slightly and rotate the assembly
shelf and pull forward. Push the shelf in to return to approximately 30 ° to allow the rear mechanism to
original position, clear the vertical rear side rails.
• The entire assembly can then be moved forward and
,_ WARNING m Never attempt to adjust clear of the refrigerator compartment.
a shelf that is loaded with food (except • To reinstall, reverse the removal procedure. Be sure
the Elevator shelf - see above), the shelf is in a level position. When the sliding
shelf is pushed to the rear, it will reposition the rear
latches to their correct operating position.
4