Table of Contents
Advertisement
ATTACHING THE TRACK CONTROLS
(Hardware F)
1. Remove the screw from the top of the right hand
track control. Be careful not to lose the flat weld
nut that is inside the control.
2. Place
the
right
underneath the right handle. Secure with screw
just removed. See Figure 12.
3. Secure the left track control in the same manner.
4. Attach track control cable to track control handle
by inserting cable ball into slot on track control
handle. Push cable down and up until it snaps
into front of track control handle. Repeat on
other side.
5. Secure the track control cables to the inside of
the lower handle using the cable ties provided.
Pull the cable ties tight, and trim the excess
ends of the cable ties. See Figure 12
Right
Track
Control
Figure 12
ATTACHING THE CLUTCH CABLES
The "Z" end of the clutch cables are hooked into the
clutch grips on each handle. Attach cables as
follows.
1. Thread the hex jam nuts all the way up the
threaded portion of the "Z" ends of the clutch
cables.
2. Make certain each cable is in groove of cable
roller guides. Place the clutch grip in the raised
(up) position.
3. Thread the cable onto the threaded portion of
the "Z" and until there is no slack in the cable,
but the cable is NOT tight. Do not overtighten
cable. See Figure 13.
WARNING:
will create a safety hazard by disallowing
the
clutch
overtighten.
track
control
in
position
Screw
Overtightened of the cable
to
disengage.
Do
4. When correct adjustment is reached, tighten the
hex jam nut against the bottom portion of the
cable to lock it in position.
ATTACHING THE SHIFT ROD
(Hardware B)
1. Place the shift lever (on the handle panel) in the
fifth speed position (all the way to the left).
2. Place the bent end of the shift rod into the hole
in the shift arm assembly. See Figure 15. Secure
with flat washer and hairpin clip.
3. Start threading the ferrule onto the other end of
the shift rod. Lift up on the shift rod (and shift
arm assembly) as far as it will go.
4. Thread the ferrule onto the shift rod until the
ferrule lines up with the lower hole in the shift
lever (beneath the handle panel). Insert the
ferrule into the upper hole in the shift lever from
the left side when adjustment is correct. Secure
with flat washer and hairpin clip.
5. Make certain to check for correct adjustment of
the shift rod as instructed in the Final Adjustment
section before operating the snow thrower.
LAMP WIRING
Right Handle
1. Wrap the wire from the lamp down the right
NOT
handle until the wire can be plugged into the
alternator lead wire under the fuel tank. See
Figure 14. Be sure lamp wire does not interfere
with the movement of any controls or cables.
9
"Z" End
Hex Jam
Nut
Cable
is Straight
Figure 13
Lamp Wire
Alternator
Lead
Figure 14
Advertisement
Table of Contents
