La Marzocco Strada EP Operating Manual page 21

Strada EP
Loading the Log
Click on File and then Log File then Load Log. A file open dialog will be displayed using the same directory as the one used for
saving the profile group files. The dialog will display all files with a .log extension. Select the file to load, click Open and the log
file will be read in. Note, at the same time, the profile group files that are located in the same directory will also be read in to be
plotted with the associated log file.
Displaying the Log
The log file may be displayed in three different forms. Clicking File, Log File, View Log will display the converted data in spreadshe-
et format. The data has been converted to BAR for pressure and Volts for the pump motor. The associated profile file number is
also displayed for each group.
Manual Programming of the Pressure Profile
Press and hold the button on the group where you wish to record the pressure profile, then on the display the sentence PRO-
FILE N° will flashing.
Now the machine is ready to be programmed, at the end press again the
All profiles programmed on the 1st group will repeated on the others.
Programming the Pressure Profile with USB
Draw the desired pressure profile with the Profile editor installed on your PC and upload it in to the USB Key. Insert the USB Key on
the Coffee Machine port and follow the display instructions.
Wait until the display will let you unplug the USB Key from the Coffee Machine Port, then you can star to use the pressure profiles
drawn.
Uploading the Pressure Profiles from the Coffee Machine to the USB Key
Insert the USB Key in to the Coffee Machine Port and follows the instructions displayed. It is possible recording directly the pressure
profile in to the USB Key, just let go off the first sentence that is appearing when you plug the USB Key and program the pressure
profile as same procedure as in the manual, then is possible to read the profiles with the Profile Editor.
www.lamarzocco.com
Clicking File, Log File, View Raw Log displays the raw (un-
converted data) in spreadsheet format. In both cases a new
column has been added to each group to display the number
of design profile that was used by the machine.
Clicking File, Log File, Plot Log will display a plot of the log
data along the design profile that was used. Since the log
contains all groups and multiple runs in each group you have
to specify which to plot using the up/down boxes in the control
box at the top of the plot. Also displayed in the control box is
the number of design profile that was used.
button and the machine is ready to repeat the profile.
V1.0
9