Previous Destinations - Mercedes-Benz S-Class 2011 Operator's Manual

Navigation
178
will appear asking whether you wish to
overwrite the existing data.
X
Yes
Select or
If you select Yes, COMAND stores the data.
Deleting a destination or the home
address from the destination memory
X
To switch on navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Destination
Select
menu bar by turning cVd the COMAND
controller and press W to confirm.
X
From Memory
Select
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
X
Option 1 – destination memory list with
character bar: proceed as described in the
"Entering characters using the character
bar" section (
X
Option 2 - destination memory list as a
selection list: select the destination by
turning cVd the COMAND controller and
press W to confirm.
The address data appears for the selected
entry.
X
Delete
Select
A prompt appears asking whether you wish
to delete the destination.
X
Yes
Select or
If you select Yes, COMAND deletes the
destination. You see a message to this
effect.
If you select No, the process will be
canceled.
i If the navigable address data for the
destination being deleted is also assigned
to an address book entry, COMAND will
also delete this data from there. If the
No
and press W to confirm.
in the navigation
and press W to
Y page 127).
and press W to confirm.
No
and press W to confirm.
corresponding address book entry does
not contain any further data, such as
telephone numbers, COMAND deletes the
entire address book entry.
Last destinations
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
was started. If the memory is full, COMAND
deletes the oldest destination. You can also
store one destination from the list of previous
destinations in the destination memory. It will
be stored there permanently.
Storing a destination permanently in
the destination memory
X
Proceed as described in the "From the list
of previous destinations" section
( Y page 176).
Storing the vehicle position in the list of

previous destinations

X
To switch on navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Position
Select in the navigation menu
bar by turning cVd the COMAND
controller and press W to confirm.
X
Store Vehicle Position
Select
press W to confirm.
COMAND stores the current vehicle
position as a destination in the list of
previous destinations.
and