Limit Indicator; Line Out Jacks - YORKVILLE EXM 400 Owner's Manual

3. Limit Indicator

The Limit Indicator will begin to flash red when the internal limiter starts to engage. The
limiter automatically lowers the level of the system to prevent the audio from clipping. The
EXM400 is at its loudest when the Limit Indicator is flickering. Turning up the level further will
not increase the system output considerably and will result in a compressed sound. Turn the
Master Level down to reduce limiting
BAL

Line Out Jacks

You will find a pair of balanced, ¼-inch output jacks below the Master Section. These jacks provide
a line level stereo signal of the input channels and Bluetooth™ connection. Use these jacks to con-
nect to recording gear, a larger PA or any other outboard gear.
Link Section
Unit Assign
In situations where additional bass or input channels are required, two EXM400 systems can be
linked together. This offers the possibility for 2 subs, up to 8 satellites speakers and 8 mixer chan-
nels.
1. Link Jack
To utilize the link feature of the EXM400, insert a ¼-inch TRS cable into the Link Jack of the two
systems. Use of a non-TRS cable will result in loss of a stereo channel.
Note: Make sure that one
2. Unit Assign Button
system is assigned Left
and the other Right.
When linking a pair of EXM400 systems, each unit must be assigned to the left or right side. After
connecting the two systems with a TRS cable via the Link Jack, assign the system on the right to
the right channel (button in, red light) and the other system to the left (button out, green light).
Assigning both systems to the same channel will result in a non-functioning link.
LINK
Speaker Out / Stereo Operation
When configured with both satellite speakers on the sub-mounted poles, the EXM400 internally
sums any stereo signals to mono. Stereo output is only achieved when two systems are linked to-
STEREO
(TWO SYSTEMS) gether or the Speaker Out Jack is used.
1. Speaker Out Jack
In order to achieve stereo output with a single EXM400 system, connect the supplied ¼-inch
speaker cable between the Speaker Out Jack and the ¼-inch jack on a satellite speaker. This inter-
nally switches the output of the sub-mounted satellites from mono summed stereo to left channel
output. The speakers attached to the Speaker Out will produce the right channel.
As with speakers connected to the top of the subwoofer, the Speaker Out Jack is capable of driv-
ing two satellite speakers max. Full system power is achieved when two satellites are placed on the
subwoofer and an additional two satellites are connected to the Speaker Out Jack.
Use the EXM400SAT
2. Microphone Stand Adapter
Extension Kit to
double fullrange output!
Included with the EXM400 is an adapter to mount satellite speakers on a standard microphone
stand. Simply thread the adapter to a 5/8-inch thread mic stand and place your satellite speakers
on the adapter.
SPKR
OUT
STEREO
(WITH EXTENSION)
NOTE: If the user wishes to run a stereo system with the subwoofer in the middle, a standard
¼-inch
banana to speaker cable can be used to connect the left channel speakers to the port on
the top of the subwoofer.
4
EXM