Dish Network DISH 1000.2 Installation Manual page 8

From the screen, run
Point Dish
and 6000, select the
SuperDISH Installation-3Sat
On all other Legacy models, select
see an Installation Summary screen similar to the ones shown below. Make sure the summary
screen shows reception from the 119°W, 110°W, and 129°W satellites on all available satellite
tuners. Also confirm the LNBF is correctly identified as a
some models may identify this LNBF as a
receivers will identify the LNBF as
: On some models, you might not see signal from 129°W until after you take a software
Note
download and run a Check Switch in steps 10 and 11. Legacy receiver models 1000, 2000, 3000,
4000, 5000, 7100, 7200, and JVC-DVHS (IRR) may not detect and will not support the 129°W
location.
: If you are using the Three-LNBF Bracket, your Installation Summary screen will vary
Note
depending on the connected switch. Make sure the summary screen shows reception from the
119°W, 110°W, and 129°W satellites on all available satellite tuners.
DISH Pro/DISH Pro Plus
Installation Summary
Exit the
Installation Summary
signal strength bar is green and locked for the 119°W, 110°W, and 129°W satellites.
: You might not see signal from 129°W until after you take a software download and run a
Note
Check Switch in steps 10 and 11.
Exit the
Point Dish/Signal
software download. Do not disturb the receiver during the process of downloading software. If
exiting the
Point Dish
least 20 minutes (on most receivers) to allow the receiver to take a software download.
Run again and confirm reception for all three satellites on all available satellite
Check Switch
tuners. Your Installation Summary screen should be similar to the ones shown above in step 8.
Some software on some models may identify the DPP 1000.2 LNBF as a
identification is OK.
If installing an additional receiver, follow steps 6-11. Make sure the summary screen shows
reception from the 110°W, 119°W, and 129°W satellites. Keep in mind that a DISH Pro or DISH
Pro Plus receiver must remain connected and powered at all times to power the DPP 1000.2
LNBF.
Check Switch
. When the Check Switch procedure finishes, you should
Test
DPP Twin
.
SW64
screen to display the
screen and follow the on-screen instructions for taking a receiver
screen does not start the download process, turn off the receiver for at
. On Legacy receiver models 2800, 3900, 4900,
option prior to running the Check Switch test.
DPP 1000.2
or , which is OK). Legacy
DPP Triple
Legacy
Installation Summary
Point Dish/Signal
(factory software on
screen. Make sure the
. This
DPP 1K.2
Page 7