Additional Skew Holes For Use With Extreme Skew Angles - Dish Network DISH 1000.2 Installation Manual

Figure 2. Additional skew holes for use with extreme skew angles
Assemble the satellite dish as shown in Figure 1, except do not attach the LNBF at this time.
: The Three-LNBF Bracket and three DP Dual (or DP Single) LNBFs can be used instead
Note
of the Integrated Adapter Bracket and the DPP 1000.2 LNBF. The Three-LNBF Bracket is not
interchangeable with the W-Bracket from the DISH 1000.
Set the elevation by loosening then tilting the dish mounting bracket to align the edge with the
required angle on the elevation scale. Tighten the elevation bolts snugly to prevent movement.
Slide the dish assembly down onto the mast. Make sure the pivot bolt rests on the top of the
mast and that the mast is fully inserted into the tab. Turn the dish assembly so that it points in
the general direction of the satellites, using the azimuth angle you wrote on page 3.
Page 4