Torque Values - Dish Network DISH 1000.2 Installation Manual

Mast pivot through bolt (ensure no mast deformation occurs during
tightening)
Mast locking nuts
Reflector mounting bolts
Clamp locking bolts
Clamp pivot through bolt (ensure no mast deformation occurs
during tightening)
Elevation adjustment locking nuts
Skew adjustment locking nuts
LNB and bracket attachment hardware
Remove the temporary cable used for peaking the dish. Thread the cable(s) from the receiver(s)
through the LNBF arm and bracket. Connect these cables to
applicable.
: If using the Three-LNBF Bracket with DP Dual (or DP Single) LNBFs, refer to the section
Note
Connecting to a Switch on page 9 and the switch's installation instructions for additional details.
Connect a cable from DPP 1000.2 LNBF
Pro Plus (dual-tuner) satellite receiver's
present, it should be installed last.
To connect DISH Pro Plus (dual-tuner) receivers with a single cable, install a
DISH Pro Plus Separator as follows:
a. Connect a cable from the DPP 1000.2 LNBF output (
) to the DISH Pro Plus Separator Input.
P 3
ORT
b. Connect cables between the receiver's
to
S
ATELLITE
Separator.
You must use a DISH Pro Plus Separator in a single-cable/dual-
tuner receiver installation. A splitter or other device will not work in this configuration.
Tighten all indoor coaxial cable connections to the receiver only by hand. If you use a
wrench, you may over-tighten the connections and damage your equipment.
Connect the receiver(s) to the TV(s) and display the
receivers, press MENU-6-1-1 on the remote control).
Page 6
Table 1: Torque Values
Location
and
I 1 S I
N ATELLITE N
Torque Value (ft-lbs unless otherwise noted)
P
(or or
P 1 P 2
ORT ORT
connection(s). If a Legacy receiver is
S I
ATELLITE N
P
ORT
and
S I 1
ATELLITE N
respectively on the DISH Pro Plus
2
Point Dish
24 in-lbs
12
6
6
24 in-lbs
12
12
Handtight
, and
1 P 2 P
ORT ORT ORT
) to a DISH Pro or DISH
P 3
ORT
, or
1 P 2,
ORT
S I 2
ATELLITE N
screen (if not shown, for most
, as
3