Chicago Electric 68857 Owner's Manual & Safety Instructions page 17

operating Reciprocating Saw
1. Slide a fully charged Battery Pack into the bottom
of the Handle, making sure that it clicks into place.
Be sure the Battery Pack is securely seated into
the Saw Handle so it will not fall off during use.
2. Firmly hold the Reciprocating Saw with both hands.
Position the Blade near the work piece, depress the
Trigger Lock Button (3) and hold the Trigger down.
3. Release the Lock Button once the tool has
power. Allow the Saw to come up to full speed
before addressing it to the work piece.
impoRtant: Do not start the Saw if the Saw Blade is in
contact with anything before operation. If necessary, lift
the tool from the work piece before squeezing the Trigger.
4. In preparation for making a cut, place the Blade
Guard (35) on the surface to be cut. Align the Saw
Blade with the direction of the cut and slowly lower
the saw blade onto the cut line to begin the cut.
Do not attempt to cut with the tip of the Blade;
kickback and damage to the Blade could result.
metal cutting
a. When cutting metal materials with the Saw,
make sure to use the metal Saw Blade.
b. Lubricate the cutting surface with cutting oil to
avoid heat build-up. Follow the "Operating
the Reciprocating Saw" section earlier
in this manual for basic instructions.
c. Slowly start the cut. You may tip the
Handle down for a slant cut.
5. When finished cutting, release the
Trigger to stop the tool.
6. Remove the Battery Pack and the Saw Blade.
7. Clean, then store the Saw indoors
and out of children's reach.
operating Flashlight
1. Slide the top of the Battery into the bottom of the
Flashlight handle until Battery locks into place.
2. Adjust the Flashlight's head position
by rotating it up or down.
Item 68857 For technical questions, please call 1-800-444-3353.
plunge cutting
WaRninG! to pRevent SeRiouS injuRY
FRom electRical ShocK and FiRe: Do not
cut into areas where you cannot identify possible
hazards behind or inside the surface being cut.
note: Before Plunge Cutting, drill a hole large
enough to insert the Saw Blade. never allow the
tip of the Saw Blade to contact the workpiece.
1. Clearly mark the line of cut on the work piece.
2. From a convenient starting point within the cut out
area, place the blade tip into the hole or opening.
The Blade Guard should be positioned vertically at
a 90° angle to the workpiece. See Figure B, below.
Drilled Hole
Saw Blade
Guard resting
on workpiece
Figure d: plunge cutting
3. Start the Saw and allow it to reach full speed.
4. With the Saw resting on the Blade Guard,
slowly tilt the Saw Blade onto the cut line.
Continue this motion until the Saw Blade
is perpendicular to the work piece.
5. Continue cutting along the line to complete the cut.
3. Press the Trigger to activate LED lights on the front
of the Flashlight. Press again to turn off the lights.
4. After use, press the battery release latch on the front
of the Battery to release the Battery Pack from the
Flashlight and slide it out of the Base to remove it.
Page 17