Chauvet SlimPAR 56 Quick Reference Manual page 4

SlimPAR 56 QRG
AC Power
Power Linking
Fuse Replacement
Connections
Diagram
DMX setup
Power linking setup
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
You can link up to 50 SlimPAR 56 products at 120 VAC or up to 100 units
at 230 VAC.
To replace the F1A, 250 V fuse in the SlimPAR 56:
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse
holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
For easy setup, use the following diagrams to physically connect your
SlimPAR 56 units to a DMX controller and each other.
*DMX controller sold separately*
4
To additional
SlimPAR 56s
To additional
SlimPAR 56s
EN