Brookstone may provide their own warranties to the purchaser, but Brookstone, in so far as permitted by law, provides these products “as is.” Warnings and Cautions........... . 1-2 This warranty does not apply to: a) damage caused by failure to follow instructions relating to product’s use or the installation of components;...
(“Warranty Period”). If a defect arises and a valid claim is received • Do not immerse transmitter or monitor in water or other liquid. within the Warranty Period, at its option, Brookstone will either 1) repair the defect • Keep transmitter and monitor away from heat and direct flame.
• Hand wash the probe with mild detergent and water. Do not machine wash. Stand • Wipe monitor and transmitter with a damp cloth. Power Button • If probe becomes damaged during use, order replacement probe (413229p) Current Temperature through Brookstone. Doneness Level Low Battery Indicator Reception Indicator Light Button LCD Screen Meat Selection 10.
AUDIBLE ALARMS MONITOR Out of range: Three beeps: activates when transmitter and monitor are more than 300' apart. Shorten distance and/or check batteries. Almost ready: Voice prompt and slow beeping: “Your entrée is almost ready.” Sounds when current temperature is within 5 degrees of the target temperature.
Page 6
LOCATION OF PARTS, CONTROLS AND INDICATORS 12. Remove MEAT PROBE from the meat. Use caution when touching MEAT PROBE or end of cable as they may be hot and may cause burns. THE TRANSMITTER AND MEAT PROBE 13. If current temperature surpasses the target temperature, an overcook alarm will sound (continuous beeping).
Page 7
IMPORTANT: FOR CHICKEN, TURKEY, AND FISH: TRANSMITTER The unit defaults to well done based on USDA guidelines. The bar graph remains in the rare range until your entrée reaches its target temperature. At this point, the graph and voice prompt will signal that your entrée is ready. FOR BEEF, LAMB, PORK, HAMBURGER, AND VEAL: 6.
® BATTERY INFORMATION GRILL ALERT OPERATION 1. Connect MEAT PROBE CONNECTOR to TRANSMITTER SOCKET. INSTALLING BATTERIES IN TRANSMITTER 2. Turn on the transmitter by pressing and holding the POWER for two seconds. 1. Slide cover and lift to open BATTERY COMPARTMENT. Light will flash on LED.