Alignment Procedure - Toshiba FT-8509 Service Manual

Test Mode For Base Unit
Press the "＊" and "#" keys at the same time about 1.5 seconds while turning the power on, the confirmation
beep will sound to indicate that the unit is in the test mode.
1. To change the TEST mode: Press the number key for the corresponding TEST mode.
2. To change channel:
3. To cancel Test mode:
STEP FUNCTION
1 VO/TX FRQ. ADJ
2 TX MODE CHECK
3 TX DATA
4 RX SENS.
5 SQ SENS.
6 RING CHECK
7 DUAL TONE CHECK
8 DATA IN CHECK
9 CHANNEL DATA CHECK
10 DUPLE
11 INT COM
*1 : "0000..." (250Hz) will be fed out continuously as transmitting data.
*2 : Bell rings when sensing SQ.
*3 : Every pushing of FLASH key makes tone change. (In the case of Dual Tone, changes as
1Ö2Ö3Ö4Ö5Ö6Ö7Ö8Ö9Ö0Ö∗Ö#Ö1.)
DTMF Frequency
ROW1 : 697
ROW3 : 852
COL1 : 1209
COL3 : 1477
*4 : Bell rings when the received data are "0000..." (250Hz).
*5 : Charge LED lights when detecting Charge ON.
Channel rotation
19 Ö20Ö21Ö40Ö1Ö2Ö3Ö4Ö5............37Ö38Ö39Ö40

ALIGNMENT PROCEDURE

(Refer to the following table)
Press the "RDL" key, but if changing the step, the channel returns to the start
channel.
Bell rings, charge the Handset or Power off.
KE START CH TX CONT
1 19
2 19
3 19
4 19
5 19
6 19
7 19
8 19
9 19
0 19
MEM 19
ROW2 : 770
ROW4 : 941
COL2 : 1336
TX MUTE RX MUTE
L L
L H
L L
H L
L L
H L
H L
L L
H L
L H
L H
3
RL CONT REMARKS
L L
L H
L L *1
H H
H/L H *2
L L
L H *3
L H *4
L L *5
H H
H L