Download Print this page

Viking VK10 Vortex Moving Head User Manual page 9

Hide thumbs Also See for VK10 Vortex Moving Head:

Table of Contents

● When choosing Run， press ENTER & there are 7 options selected using the UP / DOWN cursor

buttons as before;

DMX512

Artnet

Auto1

Auto2

Sound1

Sound2

Slave

。

3) DMX User Mode selection

Select the user mode (number of DMX Control Channels) by using the cursor UP/DOWN buttons as

before to select the appropriate user mode type as listed below;

Standard

Shapes

Extended

Extended RGBW

Full

Select for DMX 512 Via 3 pin XLR (DMX LED will flash if DMX is present)

Select for ARTNET Via RJ45 (Artnet LED will flash if Artnet is present)

Select Auto1 program – this unit becomes the Master in Master/slave setups

Select Auto2 program – this unit becomes the Master in Master/slave setups

Select Sound1 program – this unit becomes the Master in Master/slave setups

Select Sound2 program – this unit becomes the Master in Master/slave setups

Select Slave & quit to main menu so light is set as Slave

21 DMX Channels: Basic Control

35 DMX Channels: Allows creation of shapes

78 DMX Channels: allows individual RGB LED Control

96 DMX Channels: allows full RGBW individual LED Control

92 DMX Channels: allows RGBW shapes, RGB, & Patten Control

Table of Contents