Motor Settings; A) General Setting Of The Carburettor - Reely Carbon Fighter III Operating Instructions Manual

Table of Contents

Available languages



10.

Motor Settings

The carburettor is perfectly pre-adjusted for the first runs ex works. A rich carburettor setting is used to supply the

motor sufficiently with lubrication in the run-in phase. This is shown by strong white smoke development from the

exhaust.

The rich carburettor setting should be maintained for the first 2 - 3 tank fillings. Additionally, do not use any long full-

throttle phases and run in the motor carefully with different speeds.

Depending on mixture used, spark plug, muffler and ambient conditions like barometric pressure and humidity, small

changes in the carburettor setting may be required. The fine settings of idle and full throttle are only possible with the

engine well run in.

Figure 18

L Idle mixture regulating screw

H Main nozzle needle

S Setting screw for idling speed

Table of Contents

Table of Contents

Do you have a question about the Carbon Fighter III and is the answer not in the manual?