Advertisement
● Safety Instruc"ons
* It is very important to read and understand this manual completely before use. Keep this manual for future refer -
ence.
* When connec"ng/disconnec"ng cables and/or changing the phantom power se#ng or input level se#ngs, turn the
input level control knobs to zero or power switch off.
* When the phantom DC48V power is not needed, make sure the phantom switch is in the off posi"on.
* Before turning the phantom DC48V switch on, make sure your condenser microphone is designed to handle 48V DC
or the microphone may be damaged. Check the microphone's manual or with the manufacturer.
* Do not use other ba!eries than "AA" alkaline ba!eries. Do not mix fresh ba!eries with used ones.
* Remove the ba!eries if the mixer will not be used for a long period of "me to prevent ba!ery fluid leak.
● Front Control Panel
POWER INDICATOR: When the power switch ( )Is on, the LED will light in green. When the ba!ery level becomes too
low for proper opera"on, the LED will turn red. When this happens, replace the ba!eries with fresh "AA" alkaline ba!er-
ies.
CHANNEL 1, 2 & 3 INPUT LEVEL CONTROLS: Each knob controls the input volume level of the microphone connected to
the corresponding input ( ). Zero is the lowest (quietest) se#ng while 10 is the highest (loudest).
CHANNEL 1, 2 & 3 OUTPUT SELECTORS: Let you select the output of each channel between LEFT, CENTER and RIGHT.
MASTER LEVEL CONTROL: This knob controls the overall volume level of all connected sources (microphone and/or line
-level devices).
CHANNEL 1, 2 & 3 LIMITER SWITCHS: Each input channel has a switchable limiter. A$er se#ng the input volume level,
turn this switch on. The limiter circuit will be ac"vated and reduce the possibility of overload distor"on from very loud
sounds without affec"ng normal sound volume. If you prefer the overall sound quality of the mixer without the limiter
circuit engaged, leave this switch off.
INPUT PEAK LEVEL INDICATOR: When the mixer detects signal overload and distor"on, this LED will light in red. Lower
the input level by turning the corresponding input level control ( ) counterclockwise.
CHANNEL LEFT & RIGHT OUTPUT LEVEL INDICATORS: These indicators will show the output volume level of the CH L
and CH R outputs ( & ). When the indicators show red, reduce the volume level by turning the input level control
knobs ( ) or the master level control knob ( ).
BATTERY COMPARTMENT: Open the lid by li$ing it while pushing the tab.
2
Advertisement
