Fuel And Lubrication - Qualcut 3300ST Operating Instructions Manual

POWER PRODUCTS LL C.
Fitting the Nylon Cutting Head
1. To fit the nylon cutting head, remove the shield after releasing
the nut. Still holding the flange, place the nylon cutting head
on the shaft and rotate counterclockwise (H). The nylon
cutting head is now fitted.
H
2. To remove the nylon cutting head, use screwdriver to hold
flange and rotate clockwise.
Fitting the Blade
1. To fit the blade, take the outer flange off after releasing the
main nut, then put the blade, outer flange shield and nut
according to priority (I). Note the blade rotation direction (J).
Use screwdriver to hold flange and tighten nut counter-
clockwise. Ensure the nut is well tightened.
I
J
2. To release the blade, use screwdriver to hold flange and
release nut, the blade than then be removed.
WARNING: Please make sure the cutting head has
!
been assembled correctly before use.
10.
FUEL & LUBRICATION
WARNING: Petrol is extremely flammable and
!
explosive. A fire or explosion from petrol will burn
you and others
Mixing the fuel
This product is powered by a 2 stroke engine and requires pre-
mixing petrol and 2 stroke oil.
The oil mix should be 40:1. Never mix petrol and oil directly in
the engine tank.
Use unleaded petrol intended for motor vehicleuse with an
Octane rating of 87 ( [R + M] / 2) or higher. Purchase fuel from
a reputable fuel supplier.
Use the mixing container provided to mix the oil and petrol in
the correct quantities.
PETROL
1 litre
2 litres
3 litres
4 litres
5 litres
Mix only enough fuel for your immediate needs.
Fuel should not be stored for more than 30 days.
Follow these steps to mix the fuel:
1. Use the container provided for mixing fuel.
2. Mix the 2 stroke engine oil with unleaded petrol in the
container provided at the rate of 40 parts petrol to 1 part oil.
3. Mix the fuel thoroughly and also each time before re-fuelling.
4. Mix in small quantities. Do not mix more fuel than you expect
to use within a 30 day period.
5. Store fuel only in a clean, safe, approved container for petrol
- DO NOT store fuel in the fuel mixing bottle provided.
WARNING: Always stop the engine before filling
!
the tank. Never add fuel to a machine with a running
or hot engine.
3300ST
OIL
25ml
50ml
+
75ml
= 40:1
100ml
125ml