Smeg SAC106S Manual page 22

7. Press the cover completely down so that
it attaches perfectly to the bulb support.
Removing the door seal
To permit thorough cleaning of the oven, the
door seal may be removed. There are
fasteners on all four sides to attach it to the
edge of the oven. Pull the 4 edges of the
seal outwards to detach the fasteners.
What to do if...
The display is completely off:
• Check the mains power supply.
• Check whether an omnipolar switch
upstream of the appliance supply line is
in the "ON" position.
The appliance does not heat up:
• Check whether it has been set in
"showroom" mode (for further details see
"Secondary menu").
The controls do not respond:
• Check whether it has been set in "child
lock" mode (for further details see
"Secondary menu").
The cooking times are longer than those
indicated in the table:
• Check whether it has been set in "low
power" mode (for further details see
"Secondary menu").
24
Cleaning and maintenance
The display shows "ERR4":
• The door lock has not properly attached
to the door. This might be because the
door was accidentally opened during
the door lock activation. Switch the oven
off and switch it on again waiting a few
minutes before selecting a new cleaning
cycle.
If the door is opened during a fan-assisted
function, the fan stops:
• This is not a fault. It is a normal operation
of the appliance, useful when cooking
foods in order to avoid excessive heat
escaping. When the door is closed, the
oven will return to normal operation.
If the problem has not been
resolved or in the case of other
types of fault, contact your local
technical support centre.