Toyota 2016 Prius Service Manual page 557

Programming a rolling code system (for U.S.A. owners)
■
If your device is rolling code equipped, follow the steps under the
heading "Programming HomeLink
steps listed below.
Locate the training button on the ceiling mounted garage door
1
opener motor. The exact location and color of the button may
vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener for
the location of the training button.
Press the training button.
2
Following this step, you have 30 seconds in which to initiate step 3
below.
Press and hold the vehicle's programmed HomeLink
3
2 seconds and release it. Repeat this step once again. The
garage door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and hold the button a third time, and release
after 2 seconds. This third press and release will complete the program-
ming process by opening the garage door.
The ceiling mounted garage door opener motor should now recognize
the HomeLink
Repeat the steps above to program another rolling code system
4
for any of the remaining HomeLink
PRIUS_OM_OM47A29U_(U)
6-4. Using the other interior features
®
" before proceeding with the
®
signal and operate the garage door.
®
®
button for
buttons.
557
6