Adjusting Airflow Direction - Panasonic S-07MK2U6 Operating Instructions Manual

Setting the airflow
direction
To activate the swing
operation
Heating
Set the flap (vertical airflow flap) to the downward
position. If the flap is set to the upward position,
the warm air may not reach the floor.
Initial setting
To stop the swing
operation
6

ADJUSTING AIRFLOW DIRECTION

The functions differ depending on the indoor unit used. The airflow direction cannot be set using
the remote controller for any unit which is not listed below.
Y2 type, K2 type:
• Never use your hands to move the flap (vertical airflow flap) that is controlled using the remote
controller.
• When the air conditioner is turned off, the flap automatically moves toward the direction of
closing.
• The flap (vertical airflow flap) moves to the upward position when performing the standby
operation for heating. The swing operation is made after the standby operation for heating is
released, but swing is indicated on the remote controller even during the standby operation for
heating.
The airflow direction changes each time the
Press the FLAP button to set the flap (vertical airflow flap) to the downward position, and then press
the FLAP button again. This displays
Cooling and drying
The flap (vertical airflow flap) can
be set to one of three positions.
Press the FLAP button again during the flap swing operation to stop the flap at the desired position.
Then, the airflow can be set from the top position by pressing the FLAP button again.
Indicator when swing operation is stopped
Fan and heating
During cooling or drying operation, the flap will not stop at the downward position. Even if the flap is
stopped at the downward position during the swing operation, it will not stop until it moves to the
third position from the top.
FLAP button is pressed during operation.
, and the airflow automatically swings up and down.
Fan operation
Initial setting
Cooling and drying
All operations
Continuous
Initial setting operation