Prior To Using The Machine; Preparing The Machine For Use; The Importance Of Water Decalcification; Filling With Salt - Nordmende DW46WH Instruction Manual

Prior to using the machine for the first time
Check whether the electricity and supply water specifications match the values indicated by the
•
installation instructions for the machine.
Remove all packaging materials inside the machine.
•
Set the water softener.
•
Add 1 kg salt into the salt compartment and fill with water up to a level at which it will almost
•
overflow.
Fill the rinse aid compartment.
•

PREPARING THE MACHINE FOR USE

The importance of water decalcification

For a good washing function, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white
lime residues will remain on the dishes and the interior equipment. This will negatively affect your
machine's washing, drying and shining performance. When water flows through the softener system,
the ions forming the hardness are removed from the water and the water reaches the softness
required to obtain the best washing result. Depending on the level of hardness of the inflowing water,
these ions that harden the water accumulate rapidly inside the softener system. Therefore, the
softener system has to be refreshed so that it operates with the same performance also during the
next wash. For this purpose, dishwasher salt is used.

Filling with salt

Use softener salt specifically produced for use in dishwashers. To
compartment gets filled with water. Therefore, put the softener salt prior to starting your machine.
This way, overflowing salt gets immediately cleaned up through the wash operation. If you are not
going to wash any dishes immediately after putting salt, then run a short washing program with an
empty machine in order to avoid any damage ( to prevent corrosion ) to your machine due to the salt
overflow while filling in the salt container.
put softener salt, first remove the
lower basket and then open the salt
compartment cap
1 2
counter clockwise.1 2
with 1kg salt
compartment
water3at overflowing
available,using the funnel4
will make filling easier; refit the cap
and close it.When salt absent indicator
is lighten on ( app. between 20th-30th
cycles depend on the water hardness )
add salt into your machine until it fills up
(approx. 1 kg) Fill the salt
compartment with water at first use
only. We recommend that you use
small- grained or powder softener salt.
Do not put table salt into your
machine. Otherwise, the function of
the softener compartment
decrease over time. When you start
your dishwasher,
1
11
by turning it
At first fill the
and
level If
provided
may
the salt