Connecting A Bluetooth Device - JVC KD-S88BT Instructions Manual

Connecting a Bluetooth device

When you connect a Bluetooth device to the
unit for the first time, make pairing between
the unit and the device.
• Once the connection is established, it is
registered in the unit even if you reset the
unit. Up to five devices can be registered in
total. "PAIRING FULL" scrolls on the display if
you tried to pair the 6th device.
• This unit supports Secure Simple Pairing (SSP).
• Pairing sequence may be different from what
is described below.
• A maximum of two devices for Bluetooth
phone and one for Bluetooth audio can be
connected at a time.
1
] Turns on the power.
2
USB cable from the
rear of the unit
] Make sure USB Bluetooth Adapter
is connected to one of the USB input
terminals.
3 Use the Bluetooth device to search and
select "JVC Unit."
• For some Bluetooth devices, you may
need to enter the PIN code first after
search.
4 Perform one of the following pairing
operations (what appear depends on the
Bluetooth device pairing process).
(A) If "BT PAIRING" flashes, then
"[Device name]" = "VOL – YES" =
"BACK – NO" scrolls on the display.
] Select "YES" to start the pairing
process.
12 ENGLISH
USB input terminal
KS-UBT1
or
If "PAIRING" appears...
] Operate the Bluetooth device to
accept.
If "PAIRING" = "PIN 0000" scrolls on
the display...
] Enter a PIN (Personal Identification
Number) code to the Bluetooth device.
•
You can change the PIN code of your choice
before pairing. (page 17) [ Initial: 0000 ]
(B) If "BT PAIRING" flashes, then
"[Device name]" = "XXXXXX" =
"VOL – YES" = "BACK – NO" scrolls on
the display.
] Check to be sure the passkey appears
on the unit and Bluetooth device is the
same. Then, confirm the passkey on the
unit by pressing the control dial. Operate
the Bluetooth device to confirm the
passkey.
•
"XXXXXX" is a 6-digit numeric code that
appear in different combination (even if the
device is the same) each time pairing is made.
5 After pairing is successful, the unit will
establish Bluetooth connection with the
Bluetooth device*. ( lights up on the
display.)
• The device remains registered even
after you disconnect the device. Use
<CONNECT PH/ CONNECT AU> (or
activate <AUTO CNNCT>, page 17) to
connect the same device from next time
on.
*
Some devices may not be able to connect to the
unit after pairing. Connect the device to the
unit manually.