SHERCO 2014 250 SE/R Owner's Manual page 81

250-300 SE/R
Control devices and controls (continued)
Fig 6 adjustable trip distance function
Fig 7 oDo function
Fig 8 arT function
Fig 9 Clock function
Fig 11 low battery/ low
battery error function
80
Low battery/ Low battery error function:
->When the battery voltage drops to less than 2.40V, the LO battery
warning will turn on.
->When the internal battery is critically low, the unit will only display a
blinking «LO» icon.
DST and DST2 can be incremented or decre-
mented by the user
DsT set up (screen 1) → Hold the left Button
down for 3seconds → «DST» icon will flash
→ Hold left Button to decrement/ Hold the
right Button to increment → back to screen 1
DsT2 set up (screen 2) → Hold the left Button
down for 3seconds → «DST2» icon will flash
→ Hold left Button to decrement/ Hold the
right Button to increment → back to screen 2
ODO function Odometer (screen 3): displays the
total mileage traveled by the vehicle.
The total distance is displayed in the selected
units, km/h (default) or mph (
This information can not be reset to 0.
Beyond 399 999 km (or miles), the counter
goes back to 0.
ART function Accumulated Ride Time (screen 3):
displays the hours of operation of the vehicle.
This information can not be reset to 0.
Until 99h59min → displayed in one minute
increments
After 99h59min up to 9999h → displayed in
one hour increments
If the unit should reach 9999 hours of accu-
mulated ride time, the display will stop incre-
menting, and will remain at that number.
Clock function (screens 1 et 2): displays clock
information
p.17)
☛