Making Coffee; Set Water Hardness - Melitta LOOK Therm Selection DeLuxe Operating Instructions Manual

• Replacing the power cable and any other
repairs should only be carried out by the
melitta customer service or by an authorised
®
repair workshop.
Insulated pot
• Do not use the pot in the microwave.
• Do not place the pot on a hot oven.
• Do not use the pot to store milk products or
baby food as bacteria could develop.
• Do not lay the pot on its side if it contains
liquid as the liquid could leak.
• Clean tenacious staining with special cleaner.
• Use a soft damp cloth to clean the exterior.
ONLY Melitta LOOK
®
• To avoid damaging the glass flask, do not use
any hard or sharp objects to stir or clean (e.g.
cutlery, washing up brushes etc) and do not
use ice cubes or carbonated drinks with the
insulated pot.
• Do not subject the glass flask to high
temperature variations.
• If the pot is dropped or subjected to a heavy
impact the glass flask could break. Do not
drink the contents as they could contain
shards of glass.
2. Before first use:
• Ensure that the power supply in your home corres-
ponds to that on the model plate on the base of the
appliance.
• Connect the appliance to a power source. Unused
cable can be stored in the base of the appliance. 
• All appliances have been tested during production
for perfect functioning. Therefore there may be
for example water deposits remaining. rinse the
appliance twice with the maximum amount of water
and without a filter bag or ground coffee, in order to
clean it.
• For the best coffee enjoyment and convenient use,
the appliance is equipped with various features.
These features are explained below.

3. Set water hardness

Depending on water hardness lime scale may build up
in the appliance. This increases the appliance's energy
consumption as lime scale on the heating element can
prevent the water heating effectively. To avoid damage
the appliance must be descaled regularly. The descaling
display helps you in this. If the CALC-button  is
permanently lit this shows that the appliance needs to
be descaled.
The appliance is pre-set for a high level of water
hardness (level 4). You can find out the level of water
hardness in your area by asking your local water
provider or by using water hardness measuring strips
available in the shops. For softer water the descaling
display can be adjusted to descale less often:
• Hold down the CALC button  for longer than 2
seconds. The CALC button starts to flash. In the
factory settings the CALC button flashes briefly four
Selection
®
times with the following pauses ............
• You can set the water hardness at three further
levels. each time you briefly press the CALC button
 the display changes to flashing one, two or three
times, each time followed by a pause
(......, ......, ......).
• The settings and display are shown in the following
table 1.
• Once you have set the desired hardness level, again
hold the CALC button  down for longer than two
seconds. The light goes off and your settings are
saved.
Please note:
1. Water hardness cannot be programmed while
brewing.
2. The last water hardness level chosen remains even
after removing the power cable.

4. Making coffee

• Ensure that the appliance is connected to the power
source.
• Open the lid on the water tank. 
• Fill the water tank with the desired amount of water
using the therm jug. With the help of the water level
display on the tank  you can choose the correct
number of cups. Small cup symbol = approx. 85ml
coffee per cup, large cup symbol = approx. 125 ml
coffee per cup.
• Close the lid on the water tank and place the therm
jug with closed lid in the appliance.
• Open the swivel filter  to the left.
filter bag 1x4
• Fold a Melitta
®
and place it in the filter holder.  Press the filter bag
into the filter holder by hand, to ensure a good fit.
• Put the ground coffee into the filter. The amount
depends on your personal taste. We recommend
using 6g of ground coffee per large cup.
• Swivel the filter back into the appliance. An audible
click tells you it is inserted properly.
AromaSelector
• With the Melitta
®
set the taste of your coffee with just one hand:
From mild-aromatic ( ) to strong-intensive (
• Turn the appliance on . Brewing begins.
• The appliance turns off automatically short after
brewing. This avoids unnecessary use of electricity
and saves energy. You can of course turn the machi-
ne off manually at any time.
• The drip stop prevents your coffee from dripping,
when you remove the pot from the appliance. 
• With the help of the detachable inner filter you can
dispose of the filter bag simply and easily.
5. Using the insulated pot
• The brewed coffee flows through the central valve in
the insulated lid of the pot.
• To pour coffee press down on the sealing lever .
• Remove the lid simply by pressing the seals on the
side while lifting the lid up .
GB
at the embossed seam
®
 you can
®
).
7