Sony SRS-X33 Help Manual page 71

Personal audio system

Hide thumbs Also See for SRS-X33:

Table of Contents

status on the BLUETOOTH mobile phone.

Switch the call device to the speaker by pressing and holding the

3. Adjust the volume by pressing the VOL (volume) –/+ buttons on the speaker or operating the BLUETOOTH mobile

phone.

When you press the VOL (volume) –/+ buttons on the speaker or adjust the volume on the BLUETOOTH mobile

phone, the

(power) indicator flashes once in green.

When you set the volume to the maximum or minimum, the

4. To end a call, press the

If you were listening to music before the call, playback will resume when the call ends.

If you end a call by operating the BLUETOOTH mobile phone, playback will also resume when the call ends if you

were listening to music before the call.

Hint

Some BLUETOOTH mobile phones have handset use priority when receiving a call. In the case of the HFP or HSP

connection, switch the call device to the speaker by pressing and holding the

or operating your BLUETOOTH mobile phone.

The volume of music playback and calling is set independently in the speaker.

If the caller cannot hear or can barely hear your voice, talk more directly into the microphone of the speaker.

Note

The sound is output from the right speaker only during a call.

Depending on the BLUETOOTH mobile phone, playback may not pause when an incoming call arrives.

Use a BLUETOOTH mobile phone at least 50 cm away from the speaker. Noise may result if the speaker and the

BLUETOOTH mobile phone are too close.

If an audio cable is connected to the AUDIO IN jack of the speaker, you cannot listen to music of the BLUETOOTH

device. However, when the BLUETOOTH connection is active, the hands-free function is available.

Table of Contents

Troubleshooting