Samsung RB28F Series User Manual page 17

Spacer
• Remove paper on spacer and then
attach a spacer (Gray block) on the
back side of refrigerator for better
performance. Make sure a spacer
fix like above image when you install
the refrigerator. It is improving the
refrigerator performance.
(Only for RB31F***B, RB29F***B,
RB37J***9** model)
• Allow sufficient space to the right, left,
back and top for air circulation.
This will help reduce power
consumption and keep your energy
bills lower.
• Do not install the refrigerator where the
temperature will go below 10 °C.
• Please ensure that appliance can be moved
freely in the event of maintenance & service.
When installing, servicing, or cleaning
behind the refrigerator, be sure to pull the
CAUTION
unit straight out and push back in straight
after finishing.
Also, make sure your floor supports the
full-load refrigerator.
Otherwise, it may cause floor damage.
Please tie up the extra length of the power
cord at the back of the refrigerator so as
CAUTION
not to be touched on the floor preventing
the power cord from being crushed by the
rollers upon relocation.
DA68-02833A (EN)-14.indd 17
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that has
the same height as the rest of the flooring.
This surface should be strong enough to support
Spacer
a fully loaded refrigerator (or approximately 65 kg).
To protect the floor finish, cut a large section of the
cardboard carton and place it under the refrigerator
where you are working.
• Pulling or pushing the refrigerator may
• When you move the refrigerator, the
damage the floor.
Moving the refrigerator after installation
may damage the floor.
Power Cord should be fixed with the
fixer of the back side.
setting up _17
2015. 5. 19. 7:19