Maintenance; Troubleshooting Guide; Specifications - Panasonic SH-FX70 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Maintenance

Clean this unit with a soft, dry cloth.
≥ Never use alcohol, paint thinner or benzine to clean this unit.
≥ Before using chemically treated cloth, carefully read the instructions that
came with the cloth.

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt
about some of the check points, or if the solutions indicated in the table do
not solve the problem, consult your dealer for instructions.
Main unit
No power.
≥ Ensure the AC mains lead is connected
properly.
The indicator does not
≥ Turn the wireless system off and then
turn green even though
back on.
[I/D SET] is pressed
and completed the
pairing.
On your home theater unit
The wireless link
≥ There is no link between the home theater
indicator
unit and the wireless system. Turn the
(e.g. " [W1] " or an
wireless system off and then back on.
indicator) is flashing.
Alternatively, turn the wireless system off,
disconnect the AC mains lead, and then
reconnect it.
The wireless link
≥ Check that the home theater unit is turned
indicator
on, and the wireless system is turned on.
(e.g. " [W1] " or an
≥ Ensure that the digital transmitter is fully
indicator) does not
inserted into the slot of the home theater
light.
unit.
≥ Ensure the surround sound setting on the
home theater unit.

Specifications

AMPLIFIER SECTION
Output power
RMS output power
Surround Ch
125 W per channel (3 ≠), 1 kHz, 10 % THD
Total RMS power
DIN output power
Surround Ch
Total DIN power
GENERAL
Power supply
[Australia[and[N.Z.[ AC 220 V to 240 V, 50 Hz
Power consumption
Dimensions (WtHtD)
SH-TR70
SE-FX70
Mass
Wireless module
Frequency range
Number of channels
Operating temperature range
Operating humidity range
Power consumption in off mode
[Note]
1 Specifications are subject to change without notice.
Mass and dimensions are approximate.
2 Total harmonic distortion is measured by a digital spectrum analyzer.
70 W per channel (3 ≠), 1 kHz, 1 % THD
AC 110 V to 240 V, 50/60 Hz
SH-TR70
SE-FX70
65.5 mmk52 mmk8.6 mm
165 mmk91.5 mmk164 mm
SH-TR70
SE-FX70
2.4 GHz to 2.4835 GHz
0 oC to r40 oC
20 % to 80 % RH (no condensation)
approx. 0.3 W
250 W
140 W
1.5 W
43 W
0.022 kg
0.7 kg
3
11
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents