Table of Contents
Advertisement
10. General information
When repeaters are not used:
When repeaters are used:
10.2.1 Registering a repeater to the main
monitor
1
: From the top menu, touch
® [Register/Cancel] ® [Register] ®
[Repeater] ® select the number of the repeater to be
registered.
2
Registering the first repeater:
Go to step 3.
Registering the second repeater:
Select the connection method according to how you
want to use the repeater. (® page 39)
R If [Connected together] is selected, go to step 5.
3
Touch [Next].
4
Select the device that you want the repeater to
connect to.
R After this, use the repeater and complete the
following steps within about 2 minutes.
40
5
: Connect power to the repeater that you want
to register, and then press PROGRAM (A) for about
3 seconds.
R The
B
R The indicator lights when the registration is
completed.
(Depending on the signal status, the indicator
may not light in green. In this case, see the
repeater's Getting Started.)
6
: Press
Note:
R When using devices in separate buildings or over
long distances, cut outs and image distortions may
®
not be improved even if a repeater is used.
10.3 Cancelling sub monitors,
cameras, and repeaters
– Cancelling can only be performed on the main
monitor.
1
From the top menu, touch
[Register/Cancel] ® [Cancel] ® select the type of
device to be cancelled.
2
Select the device to cancel from the displayed list.
R Cancelling repeaters:
When 2 repeaters are connected together, only
the farthest from the main monitor can be
cancelled.
3
Confirm the message and then touch [Yes].
R A beep sounds and "Cancel completed" is
displayed.
4
To end the operation, press
Important:
R To prevent incorrect operations, remove the
batteries from cancelled sub monitors.
ID
indicator (B) flashes green.
.
A
®
®
.
Advertisement
Table of Contents
