Table of Contents
Advertisement
Troubleshooting
E
N
G
L
I
■
Radio
S
H
Trouble
31
Station is too far, or signals are too weak.
Too much noise in FM
aSelect other stations of higher signal level.
stereo and monaural
broadcasts.
aCheck that the antenna was installed and grounded properly.
Battery cable is not correctly connected.
Preset station is reset.
aConnect the battery cable to the terminal that is always live.
■
CD
Trouble
Disc is upside down.
Place disc in the correct direction with the label side up.
a
Disc is dirty.
a
Clean disc, referring to the section on "Notes on Discs" (
Disc is in the CD
compartment but no
sound is heard, or disc
A disc that has data other than CD-DA type is loaded.
a
Discs that have CD-DA type data should be used.
is ejected automatically.
aSome CD-R/RWs can not be played back successfully due to
incompatibility among writing software, a CD recorder (CD-R/RW drive)
and the discs. Refer to instructions for the concerned devices for details.
Disc is dirty.
a
Clean disc, referring to the section on "Notes on Discs" (
Sound skips, bad
sound quality. (e.g.
caused by noise)
aSome CD-R/RWs can not be played back successfully due to
incompatibility among writing software, a CD recorder (CD-R/RW drive)
and the discs. Refer to instructions for the concerned devices for details.
Mounting angle is over 30°.
a
Adjust mounting angle to less than 30° (
Sound skip due to
vibration.
Unstable mounting.
a
Mount the unit securely with the mounting parts, referring to the section
on Installation (
¡ Disc is defective.
¡ Mechanical trouble.
Disc is not ejected.
a
Press [u] (EJECT). If normal operation is not restored, please consult the
shop where you purchased the unit.
44
CQ-VX1300W
(continued)
Cause/Step
Cause/Step
a
page 38).
a
page 38).
■
CD (continued)
Trouble
Time is counted but no
sound comes out.
■
Cassette Tape
Trouble
No sound.
Tape sound quality is
poor.
a
page 48)
High tones are improp-
erly emphasized.
Reproduction of high
tones is poor.
a
page 48).
Wow and flutter level
is very high.
Cause/Step
When the first track contains other than CD-DA data, silent playback continues
for a while.
aSelect the next track.
Cause/Step
Blank tape is inserted in the unit.
aInsert recorded tape into the unit.
Heads are dirty.
aClean heads. (Ask a service representative for advice.)
Poor quality tape.
aUse better quality tape.
Dolby B NR tape plays with Dolby B NR off.
aSet Dolby B NR to ON.
Metal type tape plays with normal mode.
aChange Normal mode to Metal mode.
Non-Dolby B NR tape plays with Dolby B NR on.
aSet Dolby B NR to OFF.
Normal type tape plays with Metal mode.
aChange Metal mode to Normal mode.
Heads are magnetized.
aDemagnetize heads. (Ask a service representative for advice.)
Tape running mechanism is dirty or out of order.
aClean tape running mechanism, or repair it. (Ask a service representative
for advice.)
CQ-VX1300W
E
N
G
L
I
S
H
32
1
45
Hide quick links:
Advertisement
Table of Contents
