First time users must first acquaint themselves with the full 535B instruction manual. Even though all efforts have been made to ascertain the accuracy of this Guide, changes and upgrades to the products described can result in different hardware or behavior. In other words, technical data are subject to change without notice.
0 0 0 0 _ 0 0 0 Movement block Film jam in Sprocket guides Film jam in lower loop area, or film end not locked upper loop area are open Arriflex 535B Quick Guide, 4/99, Page 6...
• Open the magazine door lock, place the magazine door on the magazine and lock it. Double check by pulling up on the door. Feed shaft Film core Magazine door Hinged clip Threading aid Feed side film compartment Magazine throat Upper magazine throat opening Arriflex 535B Quick Guide, 4/99, Page 7...
Page 8
TCS value by 1. See the table at the end of the Quick Guide for the proper TCS values. SET buttons MODE button Magazine display Collapsible core Lower magazine throat opening Take-up side film compartment Arriflex 535B Quick Guide, 4/99, Page 8...
Note: On the 535B the movement block is disengaged from the drive system when it is swung away from the gate. Both the movement and the drive system can now be turned independently of each other.
Page 10
TOTAL counter on the LCD display. Upper film loop marking Knurled disc Upper sprocket roller Sprocket guide lever Movement locking lever Movement Inching knob Knurled disc Lower sprocket roller Lower film loop marking Arriflex 535B Quick Guide, 4/99, Page 10...
Turning Camera Power On The main power switch for the ARRIFLEX 535B is located on the underside of the electronics cover. When a battery is attached to the camera and the main power switch is turned on, you should see characters appear on the LCD display on the camera left side.
Note: This minus sign is the only indication that the camera 21.325 fps. will run in reverse. Pay close attention! Note: Camera direction will be set to reverse for the standard speeds (NORM) and for the programmable speeds (PS). Arriflex 535B Quick Guide, 4/99, Page 12...
Note: When you close the shutter down, you have to compensate your exposure. Open up the lens aperture one stop for a 90° and two stops for a 45° shutter angle. Adjustment screw Shutter lock Arriflex 535B Quick Guide, 4/99, Page 13...
The TCS number indicates the sensitivity of a given film stock to the wavelength of light produced by the LED that exposes the film. The TCS number is set either on the magazine (535A, 535B, 16SR 3) or on the camera directly (435, 435ES).
619 West 54th St, New York, NY 10019, USA Voice phone: 212-757-0906, FAX: 212-713-0075 Email: aweeber@cameraservice.com Information about the products discussed in this Guide and more can be found on the Arri website at: www.arri.com Arriflex 535B Quick Guide, 4/99, Page 15...