How Do I Get Started - Navman MY300LMT Quick Start Manual

How do I get started?

Note: When charging the battery for the very first time, you should charge it for at least 8 hours with your
Navman turned off. This can be done through your computer with the supplied USB cable.
Mounting your Navman in a vehicle
If the car's windscreen is tinted with a reflective coating, it may be athermic and impact the GPS reception. In
this instance, please mount your Navman where there is a "clear area".
Select an appropriate location for mounting the Navman in a vehicle.
WARNING: Ensure that your Navman does not obstruct the driver's view, or interfere with the operation of the
vehicle airbags and safety devices.
To protect your Navman against sudden surges in current, connect the car charger only after the car engine has
been started.
How do I turn on my Navman?
For the initial start-up, press and hold the Power button for 2 seconds to
turn on your Navman.
For normal operation, turn off the device by briefly pressing the Power
button. Your Navman will enter a suspended state. When you next
briefly press the Power button, your Navman will return to the Main
Menu.
To turn off your Navman, press and hold the Power button for 5 seconds.
Note: To reset the device, insert a small rod (such as a straightened
paperclip) into the Reset button of your Navman.
How do I insert a memory card?
Hold the MicroSD card by the edges and gently insert it into the slot as shown in the right diagram of your Navman.
To remove a card, gently push the top edge of the card inwards to release it, then pull it out of the slot.
2 sec
5 sec
3