Table of Contents
Advertisement
For Parts Call 606-678-9623 or 606-561-4983
For Parts Call 606-678-9623 or 606-561-4983
SECTION 5: MOWER DECK
This section contains removal, installation, adjust-
ment, and maintenance information for the 42-inch
(RZT42) and 50-inch (RZT50) mower decks.
DECK REMOVAL
Remove the mower deck from the tractor as follows:
1. Move the tractor to a level surface, disengage the
PTO, stop the engine, and set the parking brake.
2. Move the deck gauge wheels to their highest
setting (lowest deck setting).
3. Remove the 'V' belt from the PTO pulley, located
on the bottom of the engine, using one of the
following two methods.
Releasing belt tension with the idler pulley.
•
Using the deck lift handle, raise the deck to the
upper position that allows for the most horizontal
run of the belt between the deck idler pulleys and
the PTO pulley on the bottom of the engine.
•
Working from the middle of the tractor, pivot the
idler bracket and movable idler pulley rearward
away from the backside of the 'V" belt just far
enough to lift the belt up and over the idler pulley.
See Figure 28.
42 INCH DECK SHOWN
Pull Idler Pulley
Rearward
Fixed Idler
Pulley
'V' Belt
Figure 28
WARNING: The muffler at the rear of the
tractor may be extremely hot, and could
cause
serious
caution when near the muffler, or allow
the muffler to fully cool before removing
the belt.
•
From beneath the rear of the tractor, slide the belt
off of the PTO pulley on the bottom of the engine.
Movable Idler
Pulley
Idler Bracket
burns.
Use
extreme
www.mymowerparts.com
www.mymowerparts.com
Rolling the belt off the PTO pulley.
•
Using the deck lift handle, raise the deck to the
upper position that allows for the most horizontal
run of the belt between the deck idler pulleys and
the PTO pulley on the bottom of the engine.
WARNING: The muffler at the rear of the
tractor may be extremely hot, and could
cause
serious
caution when near the muffler, or allow
the muffler to fully cool before removing
the belt.
•
Sitting behind the tractor facing forward, reach
beneath the tractor to grasp the belt at the front of
the PTO pulley.
WARNING:
pinching your fingers when rolling the
belt off the PTO pulley.
•
Pull the left side of the belt rearward and down-
ward while manually turning the PTO pulley to the
right until the belt rides out onto the edge of the
lower sheave of the pulley. NOTE: If pulling the
right side of the belt, turn the pulley to the left.
•
While still holding the belt downward, continue
turning the PTO pulley until the belt is rolled off
the pulley.
4. Lower the deck to the ground using the deck lift
handle.
5. Locate the LH and RH deck support pins on each
side of the deck. Pull the deck support pins
outward and lock in the disengaged position to
release the deck from the tractor's LH and RH
deck lift arms. See Figure 29.
Rear Deck
Hanger Bracket
Deck
Support
Pin
Figure 29
6. Raise the deck lift arms out of the rear hanger
bracket slots by raising the deck lift handle on the
tractor to its highest position.
28
burns.
Use
extreme
Use
caution
to
prevent
Deck Lift Arm
Rear Hanger
Bracket Slot
Hide quick links:
Advertisement
Table of Contents
