Upper Handle - MTD 020 Series Operator's Manual

NOTE: Reference to right, left, front and rear of the lawn
mower is in relation to the operating position.
Attaching the Chute Deflector
NOTE: Use a 7/16" wrench and the hardware in Group 1
to complete the following steps.
1. Align the holes on the chute deflector with the
corresponding holes on the deck surface.
2. Insert carriage bolts up through the underside of the
deck and through the chute deflector. See Figure 3-1.
3. Secure each bolt with a washer and lock nut.
Attaching Handles
NOTE: Use an adjustable wrench, a 1/2" wrench and the
hardware in Group 2 to complete the following steps.
Lower Handle
1. Lift the rear of the deck and place it on a block of
wood to secure it.
2. Place the lower handle over the deck and align the
holes on the deck with the corresponding holes on
the handle.
3. Secure the lower handle to the deck using the hex
screws, shoulder screws, and flange lock nuts.
See Figure 3-2.

Upper Handle

1. Place the upper handle in position over the lower
handle keeping the blade control handle facing up.
2. Secure the upper handle to the lower handle using
the carriage bolts, lock washers, and lock nuts from
group 4 of the hardware pack. See Figure 3-3.
Flange Lock Nut
Flat Washer
Carriage Bolt
Figure 3-1
Flange Nut
Shoulder
Screw
Hex
Screw
Figure 3-2
Carriage
Bolt
Figure 3-3

Setup and
Adjustment
This unit is shipped
without gasoline or oil
in the engine. Fill up
instructed in the engine
BEFORE operating
Flange Lock Nut
Lock Washer
3
IMPORTANT
gasoline and oil as
operation section
your mower.