Axis M1011 Installation Manual page 91

AXIS M1011/-W/M1031-W Installation Guide
Radio Transmission Regulatory Information & EMC
This equipment generates and radiates radio frequency energy, and must be installed and operated while
maintaining a minimum body-to-camera distance of 3 feet (1 meter).
If this equipment causes harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures: Re-orient or relocate the receiving antenna. Increase the separation between the
equipment and receiver. Connect the equipment to an outlet on a different circuit to the receiver. Consult your
dealer or an experienced radio/TV technician for help. Shielded (STP) network cables must be used with this unit
to ensure compliance with EMC standards.
Tested to comply with FCC Standards FOR HOME OR OFFICE USE. This product must be installed and used in
strict accordance with the instructions given in the user documentation. This Axis product complies with the
following radio frequency and safety standards:
AXIS M1011
USA -
This equipment has been tested and found to comply with the limits for a Class B computing device
pursuant to Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection against such
interference when operated in a commercial environment. Operation of this equipment in a residential area is
likely to cause interference, in which case the user at his/her own expense will be required to take whatever
measures may be required to correct the interference.
Canada -
This Class B digital apparatus complies with Canadian ICES-003.
Europe -
This digital equipment fulfills the requirements for radiated emission according to limit B of
EN55022, and the requirements for immunity according to EN55024 residential and commercial industry.
Japan -
This is a class B product based on the standard of the Voluntary Control Council for Interference from
Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic
environment, it may cause radio interference. Install and use the equipment according to the instruction
manual.
Australia -
This electronic device meets the requirements of the Radio communications (Electromagnetic
Compatibility) Standard AS/NZS CISPR22:2002
AXIS M1011-W/M1031-W (Wireless)
USA -
Federal Communications Commission FCC
This device complies with Part 15 of FCC Rules. Operation of the device is subject to the following two
conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference that may cause undesired operation.
Canada -
This device complies with RSS-210 of Industry Canada. Operation is subject to the following
conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Europe -
EU Declaration of Conformity. This device complies with the requirements of the R&TTE Directive
1999/5/EC with essential test suites as per standards:
EN 301 489 General EMC requirements for radio equipment,
ETS 300 328 Technical requirements for radio equipment.
Japan -
This product complies with Technical Regulations Conformity Certification of Specified Radio
equipment.
Australia -
This electronic device meets the requirements of the Radio communications (Electromagnetic
Compatibility) Standard AS/NZS 4771.
Page 91