Advertisement
How to install the Auto Dialer
1. Mark and drill two holes on a horizontal line 160mm apart.
2. Insert the masonry plugs; screw the two fixing screws in the plugs leaving 2mm protruding.
3. Run a cable from the Alarm Control Panel to the Auto Dialer.
4. Trigger 1 = alarm switched neg.
5. Trigger 2 = alarm switched neg.
6. Remove the screw from the SIM card cover on the rear of the unit.
7. Slide back the SIM card holder (refer to arrows on holder) and insert SIM card with the cut corner at the top,
close SIM holder sliding back in to the lock position.
8. Replace SIM card cover and small cross head screw.
9. Install back up battery pack to the connector inside the battery compartment.
Connect the 12V power supply to terminals.(+12 and 0V).
10. Press 1 2 3 4 > ESC to turn the Dialer Off (Dialer turns on automatically when power first connected. Dialer
must be Off to enable any programming.
11. The Auto dialer will beep three times and automatically start to search for the SIM card GSM network.
12. Place the Auto Dialer onto the wall, making sure the tamper switch is pressed in.
13. When the telephone logo is displayed on the LCD, you can now start to program the Auto dialer
14. Press 1 2 3 4 > ENTER to turn the Dialer On after programming has been completed
Connections on the Auto Dialer.
Important: : The Tamper terminals are for connection to the NC (normally closed) tamper inputs on an alarm
control panel. If they are not being used, please fit a loop of cable as shown.
TAMP
TR2
TR1
0V
12V+
swt -
swt - (bell/siren switched negative, this unit will not operate off a switched ground)
Installation
12V 500mA Input
2
Advertisement
