Table of Contents
Advertisement
AQUADUCT CONTROL UNIT
7.2. Calibration factor
7.2.
7.2.
7.2.
Calibration factor
Calibration factor
Calibration factor
Enter the impulses generated by the sensor per liter. Default value is
256 Imp/l.
7.3.
7.3. Back
7.3.
7.3.
Back
Back
Back
Leaves the submenu and returns to "Settings".
8. Menu u u u „ „ „ „Fans
8. Men
Fans" " " "
8. Men
8. Men
Fans
Fans
Select one of the four fan channels from the list by turning the rotary
knob and confirm your selection by pushing the knob.
To leave the menu "temperature sensors", choose the entry "back" and
confirm the selection by pushing the knob.
Generally, the last used control mode is always used, either control via
temperature sensors, revolution speed or manual control. The entered
values are not lost when the operating mode is switched but are saved
for the next call.
8.1. Sensor 1 (a
8.1. Sensor 1 (auto)
8.1. Sensor 1 (a
8.1. Sensor 1 (a
Activates the control by temperature sensors and assigns the selected
fan one of the temperature sensors one to six or no sensor at all. If two
different sensors are assigned, the sensor that causes a higher fan speed
is used.
8.2. Sensor 2 (a
8.2. Sensor 2 (a
8.2. Sensor 2 (a
8.2. Sensor 2 (auto)
Activates the control by temperature sensors and assigns the selected
fan one of the temperature sensors one to six or no sensor at all. If two
different sensors are assigned, the sensor that causes a higher fan speed
is used.
8.3.
8.3. Set rpm
8.3.
8.3.
Set rpm
Set rpm
Set rpm
Activates the fan control via revolution speed and allows defining the
fan speed. The fan can either be turned off (0 revolutions) or regulated
in the area from approximately ¼ of the maximum speed to the maxi-
- 18 -
uto)
uto)
uto)
uto)
uto)
uto)
Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1, 37130 Gleichen, Germany
© 2008-2009
Advertisement
Table of Contents
