Before You Start - Tricity Bendix TDF09 Instruction Manual

Unpacking
In the box you should find: The deep fryer ; Frying basket; Fryer element; Removable oil
tank; Detachable lid with two filters.
If any items are missing or damaged, contact your nearest Tesco store for assistance.
Retain the packaging. If you dispose of it do so in accordance with any recycling regulations
in your area.
Positioning the Deep Fryer
Site your Deep Fryer on a firm, flat, heat-resistant work surface. Steam given off by the
cooking process may mark or damage anything above or around the fryer; keep these areas
clear. In order to avoid any fire hazards keep areas above and around the fryer clear. Leave a
clear space all round the fryer, and keep it away from the front edge of the work surface .
Unwrap the power cord from the recess in the rear of the element. Place the fryer near a wall
socket. Do not put the fryer or the power cord close to any cooking or heating appliance.
Preparation:
Before using your fryer for the first time:
1: Carefully wash the appliance.
The body of the appliance should be wiped with a
wet cloth and then carefully dried.
The oil tank, the frying basket and the appliance lid
should be well washed in warm soapy water, rinsed
thoroughly and then carefully dried.
Remove both filters before washing the lid. Lift up
the filter cover as shown. Remove the two filters.
Wash the appliance lid and filter cover and then
dry fully.
Replace the filters and the filter cover only when the lid is dry.
When replacing the filtars, always insert the charcoal filter first followed by the grease filter.
Removing and cleaning the element.
Remove the heating element:
Lift the element carefully off the fryer.
To replace the element:
Align the element with the guides in the fryer
and slide the element into place.
Clean the element:
Remove the element. Dip the element in
warm soapy water, Lightly brush the sur-
face with a soft cleaning brush. Repeat the
process using clean water and then dry the
element with a soft towel or kitchen paper.
Replace the element when it is dry.
NEVER allow water to contact the control
unit or power cord.
If you need to clean the control unit, wipe it
with a barely damp cloth and then dry fully
before operating the fryer.
After cleaning, replace the the element and prepare the fryer.

Before You Start