Boiler Overheat Thermostat; Loss Of System Water Pressure; Escape Of Gas; Maintenance - IDEAL Mexico Slimline RS 3/40 User Manual

Boiler Overheat Thermostat

(Fitted for sealed systems only)
The boiler is fitted with a safety 'cutout' thermostat. This
thermostat will extinguish the pilot and shut down the boiler in
the event of overheating. Should this occur, allow the boiler to
cool, press the reset button (E) on the overheat thermostat then
relight as detailed in steps 1-9 under 'To light the boiler'.
If the 'cutout' condition persists turn off the boiler and consult a
CORGI registered installer.

Loss of system water pressure

(Boilers fitted with the Overheat Thermostat Kit only)
If the red arrow on the system pressure gauge is set above zero
and the system pressure is seen to fall below this value over a
period of time then a water leak is indicated. In this event a
CORGI registered installer should be consulted.
DO NOT FIRE THE BOILER IF THE PRESSURE HAS
REDUCED TO ZERO FROM THE ORIGINAL SETTING
The code of practice for the installation,
commissioning & servicing of central heating systems
Caradon Plumbing Limited is a member of the
Benchmark initiative and fully supports the aims of the
programme. Benchmark has been introduced to
improve the standards of installation and commissioning
of central heating systems in the UK and to encourage
the regular servicing of all central heating systems to
ensure safety and efficiency.
CARADON PLUMBING Ltd, P.O. Box 103, National Ave, Kingston upon Hull, HU5 4JN.
Telephone: 01482 492 251 Fax: 01482 448 858. Registration No. London 322 137. Registered
Office: National Avenue, Kingston upon Hull, HU5 4JN. A subsidiary of Caradon p.l.c
6
Ideal Consumer Helpline: 01482 498660

Escape of gas

Should a gas leak or fault be suspected, contact your gas
supplier without delay.
Do NOT search for gas leaks with a naked flame.
Cleaning
For normal cleaning simply dust with a dry cloth.
To remove stubborn marks and stains, wipe with a damp cloth
and finish off with a dry cloth.
Do NOT use abrasive cleaning materials.

Maintenance

The appliance should be serviced at least once a year by a
CORGI registered installer.
Note.
The appliance model is given on the data plate, located on the
front of the boiler base plate, behind the grille assembly.
THIS SYMBOL IS YOUR
ASSURANCE OF QUALITY
These appliances are designed for use with Natural
Gas only. They have been tested and conform with
the provisions of BS. 6332 and BS. 5258.
CERTIFIED PRODUCT
Manufactured under a BS EN ISO 9001:1994
Quality System accepted by BSI
CARADON PLUMBING Ltd. pursues a policy of continuing
improvement in the design and performance of its products. The
right is therefore reserved to vary specification without notice.
September 1999
Mexico Slimline RS & CF 3/40-3/50 - Users
151913 A02