Supervisor Password - Toshiba R30-C User Manual

You can launch the BIOS setup utility to set, change or delete the HDD/
SSD Password or HDD/SSD Master Password.
Refer to

Supervisor Password

If you set a Supervisor Password, some functions might be restricted when
a user logs on with the User Password.
You can start the Supervisor Password utility by accessing the following
folder and then double-click TOSPU.exe:
C:\Program Files\TOSHIBA\PasswordUtility\
or:
C:\Program Files (x86)\TOSHIBA\PasswordUtility\
This utility lets you do the following:
Starting the computer using a password
If you have already registered a user password, there is one way to start
the computer:
The password is necessary only if the computer was shut down in
Hibernation mode or boot mode. It is not needed in Sleep mode and
Restart.
To enter a password manually, do the following:
1.
User's Manual
TOSHIBA Setup Utility
If you forget your HDD/SSD User Password, TOSHIBA will NOT be
able to assist you, and your internal storage drive will be rendered
COMPLETELY and PERMANENTLY INOPERABLE. TOSHIBA will
NOT be held responsible for any loss of any data, any loss of use or
access to your internal storage drive, or for any other losses to you or
any other person or organization that result from the loss of access to
your internal storage drive. If you cannot accept this risk, do not
register the HDD/SSD User Password.
When saving the HDD/SSD User Password shut down or restart the
computer. If the computer is not shut down or restarted, the saved
data might not be correctly reflected. For more information on shutting
down or restarting the computer, refer to
Register or delete the Supervisor Password.
Specify restrictions for general users.
Enter the password manually.
Turn on the power as described in the
following message appears in the screen:
section for further information.
Turning on the
Getting Started
power.
section. The
5-9