Using The Parts List - Xerox Phaser 5500 Service Documentation

Parts List Overview
Introduction
The Parts List section identifies all part numbers and the corresponding location of all spared
subsystem components.
Organization
Parts Lists
Each item number in the part number listing corresponds to an item number in the related
illustration. All the parts in a given subsystem of the machine will be located in the same
illustration or in a series of associated illustrations.
Common Hardware
The common hardware is listed in alphabetical order by the letter or letters used to identify
each item in the part number listing and in the illustrations. Dimensions are in millimeters
unless otherwise identified.
Service Procedure Referencing
If a part assembly has an associated repair or adjustment procedure, the procedure number
will be listed at the end of the part description in the parts list e.g. (REP5.1, ADJ 5.3).
Use of the Term "Assembly"
The term "assembly" is used for items in the parts listing that may include other itemized parts.
When the word "assembly" is found in the part number listing, there will be a corresponding
item number on the illustrations followed by a bracket and a listing of the contents of the
assembly.
Initial Issue
Phaser® 5500/5550 Printer

Using the Parts List

• No.: The callout number from the exploded part diagram.
• Name/Description: The name of the part to be ordered, appearing in UPPERCASE
letters, and the number of parts supplied per order.
• Part Number: The material part number used to order that specific part.
• Parts identified throughout this manual are referenced PL#.#.#; For example, PL3.1.10
means the part is item 10 of Parts List 3.1.
• A black triangle preceeding a number followed by a parenthetical statement in an
illustrated parts list means the item is a parent assembly, made up of the individual parts
called out in parentheses.
• The notation "with X~Y" following a part name indicates an assembly that is made up of
components X through Y. For example, "1 (with 2~4)" means part 1 consists of part 2, part
3, and part 4.
• An asterisk (*) following a part name indicates the page contains a note about this part.
• The notation "J1<>J2 and P2"is attached to a wire harness. It indicates that connector
Jack 1 is attached to one end of the wire harness and connector J2 is attached to the
other end that is plugged into P2.
NOTE: Only parts showing part numbers are available for ordering by support. Parts not
showing part numbers are only available as part of a parent assembly.
Table 1 Abbreviations
Abbreviation Meaning
C C-ring
E E-ring
KL K-clip
S Screw
March 2008
Parts List Overview, Using the Parts List
5-3
Parts List