Serial Port Parametersd; Fleet Sync Decode Check; Fleet Sync Encode Check; Mdc Decode Check Box - Telex IP-223 Technical Manual

Per Line Setup Window—Phone Mode, View 1
Serial Port Parameters Drop Down Menu
The Serial Port Params drop down menu identifies the configuration of the serial port data speed and format. Serial port
parameters refer to bit rate, parity, data bits, and stop bits. The Baud rate is used in phone mode. If phone mode is enabled on
line 1, this is the rate used to connect to the IP-223 via the HyperTerminal.
The default setting for the field, 19200.N.8.1.
REFERENCE: If necessary, refer to the Radio Dispatch and Signaling Equipment downloads available on the Telex website
(www.telex.com/RadioDispatch/) for this setting.
Serial Port Params Drop Down Menu—Phone Mode
FIGURE 42.
Signaling Setup
The Signaling Setup section is used to set up encode, decode, tone type, digits pause and duration.
IMPORTANT: The FleetSync and MDC-1200 features in this section are optional IP-223 accessories.
The "Additional Feature Setup Window" on page 122, must be also configured.
FleetSync Decode Check Box
The FleetSync Decode check box is used to enable FleetSync Over-the-Air decode. All inbound FleetSync messages are
decoded by the IP-223 instead of the radio.
FleetSync Encode Check Box
The FleetSync Encode check box is used to enable FleetSync Over-the-Air encode. All outbound FleetSync messages are
generated by the IP-223 instead of the radio.

MDC Decode Check Box

The MDC Decode check box is used to enable OTA (Over-the-Air) MDC-1200 decode. All inbound MDC-1200 messages are
decoded by the IP-223 instead of the radio.

MDC Encode Check Box

The MDC Encode check box is used to enable OTA encode. All outbound MDC-1200 messages are generated by the IP-223
instead of the radio. Motorola encode features supported by the IP-223 include PTT ID, call alert, select call, radio check,
remote monitor and radio disable/enable.
87