No.mb177)1 - JVC AX-V8000 Service Manual

3.1.4 Removing the rear panel
(See Fig.7)
• Prior to performing the following procedure, remove the top
cover, side panels and stay bkt.
(1) From the top side on the main body, remove the protect
cover and the solders from the two solder points on the AC
inlet.
(2) From the bottom side on the main body, remove the four
screws J attaching the rear panel.
(3) From the back side on the main body, remove the forty-six
screws K, two screws L and three screws M attaching each
board to the rear panel.
3.1.5 Removing the audio signal 3 board & compu link board
(See Figs.7 and 8)
• Prior to performing the following procedure, remove the top
cover, side panels and stay bkt.
(1) From the top side of the main body, cut off the tie band
fixing the wire. (See fig.8)
(2) Disconnect the wire from the connector
audio signal 1 board. (See fig.8)
(3) From the back side of the main body, remove the two
screws L attaching the audio signal 3 board to the rear
panel. (See fig.7)
(4) From the top side of the main body, disconnect the wire
from the connector CN302
fig.8)
(5) Disconnect the wire from the connector
audio signal 1 board. (See fig.8)
(6) From the back side of the main body, remove the three
screws M attaching the compu link board to the rear panel.
(See fig.7)
3.1.6 Removing the Y/C separator board
(See Fig.9)
• Prior to performing the following procedure, remove the top
cover, side panels and stay bkt.
(1) From the top side of the main body, cut off the tie band
fixing the wire.
(2) Disconnect the connectors
separator board, and take out the Y/C separator board
upward.
1-6 (No.MB177)
CN201 on the
on the compu link board. (See
CN207 on the
CN481 and CN482 on the Y/C
Solder part
Protect cover
Rear panel
K
K K K K
K J
Fig.7
CN201
Tie bands
CN207
Audio signal Audio signal
1 board
Fig.8
Tie bands
CN482
CN481
Fig.9
AC inlet
Black
Red
K
L M K
K
J J
CN302
Compu link
3 board board
Y/C separator
board