Maintenance - AEG CS 66 Instructions For Use Manual

MAINTENANCE

GENERAL
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths
to remove dirt, carbon dust, etc.
WARNING
Do not at any time let brake fluid
gasoline petroleum based pro-
ducts or penetrating oils come into
contact with plastic parts. They
contain chemicals that can dama-
ge, weaken or even destroy plastic.
EXTENSION CORDS
The use of any extension cord will cause some loss of power.
To keep the loss to a minimum and to prevent tool from over-
heating, follow the recommended cord sizes on the table.
Every 240 volt flexible extension cord shall be of heavy duty
sheathed type to comply with AS3199, Approval and Test
Specification, Cord Extension Stes.
Cord extension Conductor area
set rating sq. mm
10 1.0
10 1.5
15 1.5
15 2.5
20 2.5
20 4.0
SERVICE
Now that you have purchased your tool, should a need ever
exist for repair parts or service, simply contact your nearest
AEG Authorised Service Centre. Be sure to provide all perti-
nent facts when you call or visit.
LUBRICATION
All the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions, therefore no further lubrication is
required.
Maximum length
of flexible cord m
25
32
25
40
32
40
9