Initiating Or Answering A Radio Channel Transmission - Motorola MCD 5000 Deskset User Manual

MCD 5000 Deskset User Guide

Initiating or Answering a Radio Channel Transmission

6 80 2 9 87 C9 4 - A Ju ly 2 0 1 1
F 3-17 View Users Connected to the Same Radio
IGURE
The MCD 5000 Deskset is always in receive mode unless the
button
is pressed. When the handset is on-hook, the MCD 5000 Deskset continuously routes all
radio communication and intercom audio to the internal speaker. Alternately, if the handset is lift
(off-hook) the audio is heard via the handset earpiece and the voice is transmitted via handset
microphone.
When the headset connected do MCD 5000 Deskset, voice TX and RX are routed via the
headset.
To hear voice through the internal speaker together with the handset or headset, use the
Button Speaker Button
. When the
To visually verify that radio channel transmission can be initiated or answered, look at the
LED Busy LED
(yellow LED). If the
MCD 5000 Deskset cannot transmit until the
The MCD 5000 Deskset can be connected to a radio configured for a conventional or trunked
radio system. A conventional system uses discrete frequencies.
A trunked system selects a free radio channel automatically and notifies with an audible grant
tone when a free radio channel is found. After pressing the PTT button, be sure to wait for the
grant tone from the radio system before beginning to speak.
Use one of the following methods to initiate radio channel transmission or hear an incoming
call:
Method 1- Respond with the handset.
Procedure 3-21 describes how to respond to a call with the handset.
P 3-21 Respond to a Call with the Handset
ROCEDURE
1
Lift the handset (off-hook).
2
Press and hold the
turns on while the button is pushed.
Understanding the Emulated Radio Screen
illuminates green when the internal speaker is on.
is on, a parallel MCD 5000 Deskset is being used and
Busy LED
is off.
PTT Button
in the middle of the handset. The
PTT Transmit Base Intercom
, or
Speaker
Transmit LED
Busy
3-35