Table of Contents
Advertisement
DP-2X HORIZONTAL SIZE ADJUSTMENT
HORIZONTAL SIZE:
(Display Mode NORMAL)
Install the correct Overlay.
•
Input an NTSC Signal.
•
Digital Convergence RAM
•
should be cleared. With
Power Off, press the Service
Only switch on the Conver-
gence PWB. While holding
the Service Only Switch
down, press the Power On
button and Release. DCU
Grid will appear without
convergence correction.
NOTE: After entering
DCAM, with each press of
DO NOT USE HASH
MARKS ON:
DP-26, 27 and 27D
Overlay
Hash
Mark
6th Line
From
Center
DP-2X
43 inch
46 inch
51 inch
57 inch
65 inch
the Service Only Switch, the
picture will toggle between
Video mode and DCU Grid.
Project only the Green
•
raster by selecting Green
Adjustment mode and press-
ing the MENU button on
remote.
ADJUSTMENT
1. Adjust using R711
(Horz. Size Adj. VR) Ad-
just Horizontal Size until
the size matches the chart
below.
2) Press "Power Off" to exit
HORIZONTAL SIZE
l l l l
Between Outside Lines
DP-23/G, 24/K, 25
870 mm
930 mm
1020 mm
1140 mm
1300 mm
DCAM. (Digital Conver-
gence Adjustment Mode.)
NOTE: On the DP-26, DP-
27 and DP-27D DO NOT
USE THE MARKS ON
THE OVERLAY. The
Horizontal Size adjustment
has been increased by
20mm on the 51" and 57"
and 25mm on the 61".
DO NOT USE HASH
MARKS ON:
DP-26, 27 and 27D
Overlay
Hash
Mark
6th Line
From
Center
L=
DP-26, DP-27/27D
1040 mm
1160 mm
1325 mm
L=
—
—
PAGE 07-11
Hide quick links:
Advertisement
Table of Contents
