Final Assembly Adjustment; Raster Position; Vertical Size (Progressive Mode); Horizontal Size (Progressive And Hd Mode) - Hitachi DP05 Service Manual

2. FINAL ASSEMBLY ADJUSTMENT

2.1 Raster position adjustment
Adjustment preparation
(1) The set can face east or west.
(2) Receive the DCU cross-hatch signal.
(3) Set video conditions to factory preset.
(4) Static Focus adjustment should be finished.
(5) The digital convergence RAM should be cleared
(uncorrected state). With the TV set off, press
and hold the service switch located on the
Power/Deflection
power button.
(6) Start adjustment 20 minutes or more after TV is
turned on.
Adjustment procedure
(1) Turn the centering magnets for red, green, and
blue to satisfy the condition below. The red and
blue horizontal lines should match with green.
43FDX01B
53FDX01B
Tolerance: 2mm
R
1 2
(2) Upon completion of adjustment, fix beam center-
ing magnets with white paint.
NOTES: (1) If internal cross-hatch does not appear
after clearing RAM data, press service
switch again.
(2) To restore old RAM data, turn TV off and
on.
2.2 Vertical size adjustment
Adjustment preparation
(1) The set can face east or west.
(2) Set video conditions to factory preset.
(3) The electric focus and horizontal position adjust-
ment should have been coarse adjusted.
(4) Start adjustment after TV is turned on for 20
minutes or more.
Adjustment procedure
PROGRESSIVE MODE
(1) Receive any NTSC signal.
(2) Press and hold the SERVICE ONLY SW on
DEFLECTION PWB to display DCU crosshatch
with convergence data cleared.
(3) Adjust V. SIZE as following by using R630.
(4) After adjustment, press SERVICE ONLY switch
to exit from DCU crosshatch.
PWB and then press the
(RED) (BLUE)
1
2
20 35
15 25
B
Geometric
center of the
screen
V. SIZE SPECIFICATION
=
43FDX01B
53FDX01B
Notes: (1) Only adjust the vertical size for
progressive
Because both modes (NTSC and
HD) have the same vertical freuen-
cy.
(2) If internal cross-hatch does not
appear after clearing RAM data,
press service switch again (on
POWER/DEFLECTION PWB).
(3) To restore old RAM data, turn TV
off and on.
2.3 Horizontal size adjustment
Adjustment preparation
(1) The set can face east or west.
(2) Set video conditions to factory preset.
(3) BEAM FORM adjustment should be finished.
(4) Convergence should not be corrected.
(5) Start adjustment after TV is turned on for 20
minutes or more.
Adjustment procedure
PROGRESSIVE MODE
(1) Receive any NTSC signal.
(2) Press and hold the SERVICE ONLY SW on
DEFLECTION PWB to display DCU cross-hatch
with Convergence data cleared.
(3) Convergence should not be adjusted.
(4) Adjust H. SIZE by using R683.
(5) After adjustment, press SERVICE ONLY SW to
exit from DCU cross-hatch.
HD MODE
(1) Input 1080I (fH=33. 75kHz) component signal to
VIDEO 2.
(2) Press and hold the SERVICE ONLY SW on
DEFLECTION PWB to display DCU cross-hatch
with convergence data cleared.
(3) Adjust H. SIZE using R686.
(4) After adjustment, press SERVICE ONLY SW to
exit from DCU crosshatch.
H. SIZE SPECIFICATION
43FDX01B
53FDX01B
16
PROGRESSIVE
MODE
550
670
Tolerance: 5mm
mode (NTSC).
PROGRESSIVE
=
MODE
860
1050
Tolerance:
HD
MODE
860
1050
5mm