Water Outlet - Bosch WAQ283S1GB Instruction Manual And Installation Instructions

Wa series
Table of Contents

Advertisement

Cold water connection
Connect the water supply hose to the
water tap (¾" = 26.4 mm) and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
Model: Standard
Model: Aqua-Secure
Model: Aqua-Stop
Carefully turn on the tap and
Carefully turn on the tap and
Carefully turn on the tap and
Note:
check that the connection points are not
check that the connection points are not
check that the connection points are not
leaking. The screw connection is under
leaking. The screw connection is under
leaking. The screw connection is under
water pipe pressure.

Water outlet

Caution!
Water damage
If the drain hose slips out of the wash
basin or the connection point during
draining due to high water pressure, any
escaping water may cause water
damage.
Secure the drain hose so that it cannot
slip out.
Do not kink the water drain hose
Note:
or put strain on it lengthways.
Positioning and connecting
You can lay the water drain hose as
follows:
Outlet in a sink
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of
scalding if you come into contact
with hot detergent solution e.g. if hot
detergent solution is being drained
into a wash basin.
Do not reach into the hot detergent
solution.
Caution!
Damage to the appliance/fabrics
Damage to the appliance/fabrics
Damage to the appliance/fabrics
If the end of the drain hose is
If the end of the drain hose is
If the end of the drain hose is
immersed in the drained water, water
immersed in the drained water, water
immersed in the drained water, water
may be sucked back into the
may be sucked back into the
may be sucked back into the
appliance and may damage the
appliance and may damage the
appliance and may damage the
appliance/fabrics.
appliance/fabrics.
appliance/fabrics.
Make sure that:
Make sure that:
Make sure that:
– The plug does not block drainage
– The plug does not block drainage
– The plug does not block drainage
from the sink.
– The end of the drain hose is not
– The end of the drain hose is not
– The end of the drain hose is not
immersed in the drained water.
– The water drains away quickly
enough.
Drainage into a siphon
The connection point must be
secured using a hose clamp with a
diameter of 24-40 mm (available
from specialist dealers).
en
29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents