Childproof Lock; Adding Laundry; Changing The Programme; Cancel The Programme - Bosch WAQ283S1GB Instruction Manual And Installation Instructions

Operating the appliance
en

Childproof lock

Prevent the set functions of the washing
machine from being accidentally
changed by activating the childproof
lock when the programme has started.
To activate the childproof lock, press
and hold the "Start" button for approx.
five seconds. ²» appears in the display
panel and then goes out again after a
few seconds.
To deactivate the childproof lock, press
and hold the "Start" button for approx.
five seconds.
Notes
²» lights up: The childproof lock is
■
active and the programme selector
has been adjusted. To prevent the
programme from stopping, turn the
programme selector back to the
original programme.
The childproof lock remains active
■
after the programme has ended and
the appliance is switched off. You
must always deactivate the
childproof lock if you want to start a childproof lock if you want to start a childproof lock if you want to start a
new programme.

Adding laundry

After starting the programme, you can After starting the programme, you can After starting the programme, you can
add or remove laundry: add or remove laundry: add or remove laundry:
Press the "Start" button to pause the Press the "Start" button to pause the Press the "Start" button to pause the
1.
programme.
The "Start" button indicator lamp
flashes and the machine checks
whether it is possible to add laundry.
Do not leave the washing
Note:
machine door open for too long
when adding laundry as water from
the laundry may leak out.
If the following appears in the display
panel:
– YES lights up, it is possible to
add laundry.
16
– NO flashes, wait until YES lights
up.
Only open the washing machine
door if YES is lit up.
– NO lights up, it is not possible to
add laundry.
For safety reasons, the washing
machine door remains locked
when the water level or
temperature is high, or while the
drum is rotating, and it is not
possible to add laundry during
this time.
To continue the programme, press
2.
the "Start" button again.

Changing the programme

Changing the programme Changing the programme Changing the programme
Press the Start button to pause the Press the Start button to pause the Press the Start button to pause the
1.
programme. programme. programme.
Select a different programme. Select a different programme. Select a different programme.
2.
Press the Start button again. The Press the Start button again. The Press the Start button again. The
3.
new programme starts from the new programme starts from the new programme starts from the
beginning. beginning. beginning.

Cancel the programme

Cancel the programme Cancel the programme Cancel the programme
Press the Start button to cancel the
1.
programme.
To cool the laundry: Set the
2.
programme to Rinse.
Press the Start button again. The
3.
rinse programme starts.
After the programme has ended, you
can remove the laundry.

Programme end

‹ appears in the display panel and the
start button indicator lamp is off.
If the 9 symbol also appears in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.