Connection Method 4 - Sony SRS-X88 Help Manual

Help Guide
How to Use
Personal Audio System
SRS-X88
Connection method 4: Connecting to a Wi-Fi network using an iPhone/iPad/iPod touch
Note that the speaker should be initialized to the factory default for this connection. All BLUETOOTH device registration
(pairing) information is deleted.
The speaker can be connected to the same Wi-Fi network as the iPhone/iPad/iPod touch, if the iPhone/iPad/iPod touch
is iOS 8 or later. The Wi-Fi settings of the speaker is made by the iPhone/iPad/iPod touch.
Do the following before starting.
Disconnect the LAN cable (not supplied) from the speaker.
Place the speaker near the wireless router and the iPhone/iPad/iPod touch.
Set the Wi-Fi antenna on the rear to the upright position.
Make sure that the iPhone/iPad/iPod touch is updated to iOS 8 or later.
1. Connect a iPhone/iPad/iPod touch to the wireless router.
Connect it to 2.4 GHz band (11b, 11g, and 11n) or 5 GHz band (11a and 11n). The speaker is not compatible with
IEEE 802.11ac.
2. With the speaker turned on, tap and hold the VOL (volume) – button and the
time for more than 5 seconds.
(on/standby) button at the same
252