Fitting The Burners - Vaillant atmocraft Installation And Maintenance Instructions Manual

2
1 1
Fig. 4.15 Inserting the temperature sensor into the immersion
sleeve
• Insert the temperature sensor into the lower
immersion sleeve (1) on the left of the boiler.
• Stick the enclosed identification plate (2) to the top
left of the intermediate wall.
3
4
5
Fig. 4.16 Inserting the temperature sensors into the immersion
sleeves
• To do this you must insert the immersion sensor for
STL (1, with capillary tube) and the temperature sensor
(2, connect red plug to the electronic box) and the
empty sleeve (3) into the bottom immersion sleeve.
• Place the clamping spring (4) between the immersion
sensors and push them, together with the sensors into
the immersion sleeve up to the stop.
• Lock everything in position using the clamping spring (5).
Installation and maintenance manual atmoCRAFT
4.6

Fitting the burners

2
1 1
Fig. 4.17 Inserting the burners
• Insert four screws in the pockets in the end links.
• Place the burner (1) onto the screws (2).
Make sure that no items are lying on top of the
burner!
• Loosely screw the burner onto the screws using the
washers and hex nuts.
1
2
Fig. 4.18 Fitting the gas connection line
• Remove the dust protection from the gas fitting.
• Check that the O-ring for sealing the gas connection
line is securely located in the gas fitting.
• Push the pipe through to the back next to the boiler
and screw the connection flange to the gas fitting.
Above 130 kW the gas pipe must be pre-assembled
from the two pipes supplied.
Assembly 4
2
GB 17